Get matched with top masons in Underwood, WA

"A delivery truck backed up too far into a loading dock on our business property damaging the wall and causing the overhead door to be inoperable. We had difficulty finding a competent contractor to take on this repair. Within a few days of contacting Tom, he visited the property and had an estimate prepared. We had some concerns about the large amount of deposit that he required. He did explain that obtaining a large deposit has become commonplace among contractors in the area so they will be paid. So we went ahead and sent him a check for the deposit. Once he had received the payment, he started the work within a couple of days and was completely finished in less than two weeks. He kept us informed along the way of his progress. The cost of the repairs seemed reasonable under the circumstances. I would not hesitate to use Tom again."

"We needed some posts in our basement replaced with proper footings. TerraFirma was quick to respond and quick to do the work. We are very happy with the result and would recommend."

"They did a great job on schedule."

"I was contacted by Abraham Torres in the Spring of 2022 to arrange for work to be completed from a bid he submitted on October 5, 2021. The work included completing three concrete aprons, one to replace the damaged attached garage driveway apron and other two were added as an entrance and exit for the shop lean-to. We arranged to begin the work June 21, 2022. He informed me that he and 3 additional individuals would arrive that day and begin prepping and setting up forms on the job site. I discussed with him and agreed to increases in material costs and a change from rebar to wire mesh, which increased the cost to $7000. The job proposal required 4 workers to complete the project in 3-5 days. Abraham and Gabriel spent only spent 1 day prepping and 1/2 day pouring and left their father, Gabriel Sr., and Omar, the younger brother, to finish the rest of the 2nd day. They failed to complete the remaining day(s) as per the estimate. There have been several different issues associated with the marksmanship of JG7 Concrete that surfaced during this project. First, concrete was splashed on the existing adjacent concrete slab in front of the shop door as well as the lower metal shop siding and corner mouldings of the lean-to. I had to purchase Liquid Hammer for $30 to remove the dried concrete splashed on the metal siding and corner mouldings. Secondly, I discovered that either the loader of their John Deere or jackhammer had damaged the bullnose edge of my interior garage concrete. I made it quite clear to Gabriel Jr. that there was absolutely no existing damage along that bullnose edge, other than a small chip under the south moulding. I advised him to be extra careful to avoid such damage while jackhammering and removing the concrete pieces. I subsequently called Abraham to inform him of the problem and requested he repair the damage. He claimed he would do so, made arrangements on two separate occasions to complete the repair, and never did so. My wife and I postponed a trip to Redmond during the second scheduled date and he failed to show, or even call. He’s made no subsequent attempt to complete the repair. Thirdly, Abraham apparently had no plans to backfill along the edge of each concrete apron, thereby leaving the edges of each apron exposed. His younger brother, Omar, attempted to do so the second day by going to Mathews Construction and getting substandard material (filter sand with a considerable amounts of rock) to utilize as backfill. It has subsequently compacted following rain and the grass refuses to take root in the sand. I will now have to hire a landscaper to bring in proper backfill soil to properly shore up the edges of the concrete and allow for proper germination and growth of the missing grass. Lastly, the concrete aprons on my garage and lean-to entrance puddle water. The water puddles on the sections of concrete between the joints and concrete edges because the concrete is pitched away from the edges of the apron and joints toward the middle of each concrete section. Even though JG7 Concrete is now working under a current Oregon Construction Contractors Board license, it was not doing so when they began the project. After they began on June 21, 2022, I discovered their CCB license had expired, even though I had previously made payment of the required 50% of the estimated amount. If you decide to use JG7 Concrete for a concrete project, you might wish to consider the following issues. Mask existing concrete and building surfaces to ensure splattered concrete can be easily removed or be prepared to remove such concrete before it dries. Make sure any damage created by JG7 Concrete to existing concrete or buildings is repaired prior to final payment. Ensure that the project is completed in its entirety. All backfilling and replacement of grass should be completed prior to final payment. Lastly, hold JG7 Concrete to their contract commitment. They should spend the time allotted as outlined in the contract, with the stated number of individuals to complete the project without shortcuts."

"Israel suggested a lessor expensive fix for the hole in the siding. I am very please with his work. So we hired him to do more work."

"Purchased a 1906 home in North Portland with an uneven foundation that had been patched for 60 years, but needed serious stabilization work. I contacted multiple foundation contractors in the greater-Portland area and Ram Jack was the only team that provided a full worse-case estimate that included everything that I may need to permanently stabilize the home's foundation. Other contractors' estimates were higher, omitted some of the features of Ram Jack's estimate, and involved greater excavation work around the home. While I was collecting estimates, I had multiple contractors check the levels on the house and could see the home was continuing to sink as much as half and inch in some areas within only a few months, so I knew I had to do something soon as the hotter summers are causing significant erosion to the clay soil in north portland. After paying the 50% down payment, I was quickly in touch with multiple project managers and structural engineers who were able to answer my questions as the work plan developed. I work from home and have two cats, so I was a bit worried about the noise and needing to leave at certain times during the work. Ramjack devised a plan of installing 12 helical piers from the basement and 2 outside for a small crawl space area as well as replacing most of the piers in the basement that had water damage. During the excavation and pier installation, I didn't have to leave my house at all, my cats were fine, none of the utilities ever needed to be turned off and none of the neighbors said they heard more than the hum of the generator outside; insane professionalism. The work team kept me informed at every step of the excavation and pier installation and was able to recover an inch of lift with only a few drywall cracks that I patched in a day. I could have gone further, but wanted to avoid any potential damage to the sewer pipes and stay within my budget. During the lifting, I was standing with the lead construction manager who kept me informed of every risk as we lifted the house bit by bit. During the excavation my basement looked insane with mounds of dirt everywhere, but the construction team cleaned everything flawlessly; all I had to do was a quick mop and the basement was good as new again. Overall had a great experience with RamJack; the 20 years in business shows, most everyone I dealt with had been working with them for years; the construction manager had been doing pier installation for 15 years. The work was expensive, but cheaper than the other local contractors, and certainly way cheaper than replacing the entire basement foundation. Ramjack was even able to take a few grand off the intitial worse-case estimate for solutions not needed. Glad I was able to repair my 120 year old home; here's to another 100 years. Big thanks to Pancho and Stephen, as well as the structural engineers and project managers; I'm very happy with the work."